Securing the Top Cover
It is best to secure the top cover with the three thumbscrews on the back of the unit when carrying,
transporting or shipping the expansion unit. If required, additional retention of the cover may be achieved
using the four mounting holes under the enclosure.
NOTE: All Roben 3 models come with the 4 mounting screws (enclosed in a small plastic bag) for the option
of securing the bottom part of the cover to the chassis.
1.
Turn over the expansion chassis to expose the bottom part where the mounting holes are located as
shown for the pictures below.
2.
Install the screws to their designated mounting holes to secure the bottom part of the cover as shown
from the pictures below.
Roben 3 | Chapter 4
Advanced Technical Information
Magma
54