Installation-Procedures Overview; Open Enclosure - Magma Roben-3TX User Manual

Installation-Procedures Overview

Below is the concise version on how to set up the Roben-3TX
1.

Open Enclosure

2. Install Thunderbolt Interface card(if not installed)
3. Install PCIe cards (see notes below)
4. Attach Power Cord
5. Connect to Electrical Outlet
6. Plug in Thunderbolt Cable
7. Power on Computer
8. Hardware Check
9. Verify Installation (via Operating System)
NOTE
It is highly recommended to install 3
have verified and tested that the Magma expansion chassis is functional and free of
hardware failures.
When installing 3 Party PCIe card, start with one card first just to see if there are any software and/or
rd
hardware issues or incompatibility problems that may occur. This way you can troubleshoot the problem
more easily and efficiently. If everything works well and there are no configuration issues, you can proceed
with the installation of the remaining 3
Always refer to or read "3
Open Enclosure
Loosen the thumbscrew that retains the top cover of the chassis and slide the lid towards you as shown
below:
rd party PCIe cards.
party manufacturer installation guide" for further instructions
rd
party PCI-E cards / High Power PCIe cards after you
rd
Roben 3 | Chapter 2 Hardware Installation 14
Magma