Installation; Removal - NEC Express5800 Series User Manual

Chapter 2 Preparations

Installation

Install a backup device by using the following procedure.
1. See Chapter 2 (1.2 Overview of Installation and Removal) for preparations.
2. To remove the side cover and the front bezel, see Chapter 2 (1.3 Removing the Side Cover and 1.4
Removing the Front Bezel).
3. Remove the blank cover. Push the tab on the tray
and pull out the device tray from the 3.5-inch
expansion bay.
4. Mount the backup device on the device tray.
Secure the backup device on the left and right sides
by using the two screws that come with the server.
5. Insert the backup device into chassis.
Do not push the backup device in completely as the
cable has to be connected to the device.
6. Connect the interface cable and power cable to the installed backup device.
For more information, see Chapter 2 (1.16 Connecting Cables).
7. Push the device all the way until it locks with a clicking sound.
8. Assemble the server.
9. Install device drivers for installed backup device as needed.
For more information, refer to the manual provided with the backup device.

Removal

You can remove the backup device by reversing the installation procedure.
Use two screws supplied with this server to attach the backup device to the
Important
tray.
Tips
Arrange the unused power supply cable at the rear of the backup device so that this
cable comes between the HDD cage and optical disk drive. Be careful not to apply
a force to the I/F cable connector when pushing in the backup device.
Express5800/T110j-S, T110j-S (2nd-Gen) User's Guide
1. Installing Internal Optional Devices
1
2
79