High Temperature Resistant Kit - NEC Express5800 Series User Manual

Chapter 2 Preparations
1.14

High Temperature Resistant kit

The N8181-140F high-temperature resistant kit of this server enables you to use this server under the
environment of 5°C to 48°C.
When the high-temperature resistant kit is purchased, the following configuration is required.
• The cooling fan (for rear) is used as the dedicated fan.
• When N8154-82F 2.5-inch Hot Plug Drive Cage Kit is used, the air duct (for HDD) is added.
• In this case, length of the card that can be mounted to PCI slots 1 to 3 is limited to 148 mm or
shorter(N8104-150/151, N8117-01A).
• Below OPTION can not be installed::
N8154-83F 2.5-inch Hot Plug Drive Cage Kit
N8151-105 Internal RDX(USB)
N8118--307 Dual M.2 SATA mount kit
N8181-152 Internal battery module
N8181-153 Internal battery controller
N8105-53 Graphics Accelerator
N8105-52 NeoFace Accelerator
For details, see the User's Guide that comes with N8181-140F High Temperature Resistant Kit.
1) Connect the AC cord to the server, then push the power switch to power on.
2) If following message appears, push POWER switch in order to power off the server.
Error：System HWID doesn't match with system SKU ROM ID, please do AC power off/On after 10
3) Remove the AC cord from the server, and leave the AC power of the server off around 30 seconds.
4) Connect the AC cord to the server again, and push POWER switch in order to power on the server.
88
Express5800/T110j-S, T110j-S (2nd-Gen) User's Guide
1. Installing Internal Optional Devices