Installing The Hard Disk Drive - NEC Express5800 Series User Manual

Chapter 2 Preparations

Installing the hard disk drive

Install a 2.5-inch hard disk drive in the server by using the following procedure.
Unlock and open the door of the 2.5-inch
drive bay.
Remove the dummy tray where install the
HDD slot.
Install the hard disk drives in the HDD cage.
① Fully open the lever on the hard disk
drive tray, and then insert the hard disk
drive until it comes into contact with back
of the HDD cage.
② When finished, close the lever to lock the
hard disk drive.
Close the door and lock it by using the key.
 Use only the hard disk drives provided by NEC. For details, contact your
Important
sales representative.
 If you remove two or more hard disk drives while the server is on, the logical
drive will be damaged. Remove or replace the hard disk drives one by one.
Note Make sure that the orientation of the hard disk drive (tray) is correct before insertion.
In addition, make sure that the hook of the lever engages with the frame of the HDD
cage when the lever is closed.
Express5800/T110j-S, T110j-S (2nd-Gen) User's Guide
1. Installing Internal Optional Devices
1
2
75