NEC Express5800 Series User Manual page 65

Chapter 2 Preparations
15. Motherboard's Jumper setting
The jumper on motherboard must be configured when using this product. When using this product, set
jumper (TESLA_P4) on the motherboard to "Enabled" (Set to 2-3).
If this product is not used, set jumper (TESLA_P4) on the motherboard to "Disabled" (Set to 1-2).
Rear Side
16. Attach the side cover
17. Attach the AC cable.
18. Power on the server.
The message to suggest off/on of AC power in POST is indicated because HWID isn't identical, so
put it into effect by the next procedure.
(1) Push the power switch of the server and the power supply of the server is turned off.
(2) Remove power cord of the server.
(3) Connect the power cord to the server after you wait for more than 30 seconds.
(4) Push the power switch and the power supply is turned on, and you confirm that a message isn't
indicated again.
Express5800/T110j-S, T110j-S (2nd-Gen) User's Guide
1. Installing Internal Optional Devices
TESLA_P4
3 2 1 3 2 1
Enabled Disabled
Front Side
65