Turning On The Server - NEC Express5800 Series User Manual

Chapter 3 Setup
1.

Turning on the Server

Turn on the server by using the following procedure.
1. Disconnect Flash FDD if applicable.
2. Turn on a display, uninterruptible power supply (UPS), and other peripherals.
3. If STATUS LED 1 turns on green and STATUS LED 2 terns on amber, wait until them are unlit.
4. Press POWER Switch at the front of the server.
POWER LED is turned on green and after a while, the
NEC logo appears on the display.
While the NEC logo is being displayed, the self-
diagnostic program (POST) runs and diagnoses the
hardware. For details, see Chapter 3 (1.1 POST).
Important
Wait for at least 10 seconds before turning on the server again after the power
has been turned off.
Important
Do not connect or disconnect USB device while POST is running.
Express5800/T110j-S, T110j-S (2nd-Gen) User's Guide
1. Turning on the Server
POWER
Switch
POWER
LED
113