Optical Disk Drive; Replacing Drives - NEC Express5800 Series User Manual
Hide thumbs
Also See for Express5800 Series:
- User manual (574 pages) ,
- Maintenance manual (238 pages) ,
- Installation manual (75 pages)
Table of Contents
Advertisement
Chapter 2 Preparations
1.11
Optical Disk Drive
Procedures for replacing the standard optical disk drive with the optional internal DVD Super MULTI drive are
described below.
Replacing drives
Follow the procedure below to replace your drive with the optional internal DVD Super MULTI drive.
1.
See Chapter 2 (1.2 Overview of Installation and Removal) for preparations.
2.
To remove the side cover and the front bezel, see Chapter 2 (1.3 Removing the Side Cover and 1.4
Removing the Front Bezel).
3.
If a device or an extra 2.5-inch HDD cage is installed in the 3.5-inch expansion bay (1), remove it so
that you can access the cable connected to the optical disk drive.
4.
Disconnect the SATA cable and DC power cable
from the optical disk drive.
5.
Push the stopper on the right side and remove the
optical disk drive.
6.
Remove the bracket from the optical disk drive.
76
Important
Do not install a third party drive.
Express5800/T110j-S, T110j-S (2nd-Gen) User's Guide
1. Installing Internal Optional Devices
Stopper
Advertisement
Table of Contents
