3-4.2 To Verify 6/8-Channel Audio On Volume Control - SOLTEK B9A-FGR Manual

3-4.2 To verify 6/8-channel Audio on Volume Control

After installation of CMI8768 Audio Driver, you must configure the 5.1
(7.1) Speaker connection to enable the 6/8-channel audio.
1. Connect your on-board Audio Connector to your 6/8-channel speakers
as depicted in the figure below:
Center/ Subwoofer
Speaker Out
To Rear Speaker Out
2. After Connection is done, start your Windows and double click the
"Xear 3D" icon in the taskbar to enter volume configuration:
Chapter 3 Software Setup
To Side Speaker Out
To Front Speaker Out
double click
43