Ide Connector Installation - SOLTEK B9A-FGR Manual

SL-B9A-FGR

2-6 IDE Connector Installation

IDE1 and IDE2 are 2 IDE connectors supporting 4 IDE devices for up to
133MB/s data transfer. IDE1 and IDE2 are also supported by nForce3
to support IDE RAID system setup with 4 IDE hard disks.
nVidia nForce3 chipset
supports IDE1 and IDE2 for
4 IDE hard disks to set up
IDE RAID system.
Hard Disk Drive Connector
Orient the red line on the
IDE Flat Cable to Pin1.
Pin 1 (to Red Line)
80-conductor IDE Cable
(for 2 IDE devices)
This kind of cable is dedicated for Mini-
barebone system because the ribbon is
bundled up and will not block the air
flow in the barebone cabinet.
Gray connector
(To slave device)
Red line
Black connector
(To Master Device)
Blue connector
(To Mainboard)
22
C-Media
CMI 8768
1
JAUD1
CICADA
SimpliPHY
CIS8201
VIA
VT6307S
SATA2
SATA1
NJ1
nVIDIA
nFORCE3
250 Gb
JBAT1
USB3
IDE2
USB4
1 1
J2
Fan3 IDE1
80-conductor IDE Cable
(dedicated for 1 IDE device)
This kind of cable is dedicated for Mini-
barebone system because the ribbon is
bundled up and will not block the air
flow in the barebone cabinet.
Bundle Strap
80-conductor
IDE cable
Blue connector
Black connector
(To Mainboard)
(To Master Device)
JKB1
Fan2
Winbond
W83627HF
FD1
+12V Power
IDE1
Fan1
Main Power
Red line