Replacing The Connectivity Module; Replacing The Connectivity Module (Hardware) - Siemens SIMOTICS CONNECT 400 Operating Instructions Manual

8.5

Replacing the connectivity module

8.5.1

Replacing the connectivity module (hardware)

Connectivity module as a spare part
You can order the connectivity module as a spare part (Page 204). The battery is not connected
and it has no motor parameters. You must configure the device from new.
Procedure
1. At the front cover release the two central fastening screws.
To avoid losing the screws, do not turn the screws completely out of the cover.
2. Remove the front cover.
3. Withdraw the battery connector.
4. Release the 4 fastening screws that fix the connectivity module to the holder.
5. Remove the connectivity module from the mounting bracket.
6. Place the new connectivity module in the mounting bracket.
7. Retighten the 4 fastening screws.
8. Insert the battery connector.
9. Put the front cover back in position. Ensure that the cover fits precisely.
10.Tighten the 2 central fastening screws at the front cover by hand.
11.Reconfigure the connectivity module (Page 37).
SIMOTICS CONNECT 400
Operating Instructions, 04/2023, A5E50161952B AL
8.5 Replacing the connectivity module
Maintenance
139