Siemens SIMOTICS CONNECT 400 Operating Instructions Manual page 41

"Device overview" page
When the "SIDRIVE IQ Config" application starts, by default, you see a list of all of the currently
visible assets on the "Device overview" page. You can also display all of the assets visible in the
history. A list entry contains the information about an asset. The following diagram explains the
pictograms in a list entry.
①
②
③
④
⑤
⑥
⑦
Procedure
1. Open the "SIDRIVE IQ Config" application.
2. Select an asset.
3. Tap on the ">" button to establish a connection to the connectivity module.
SIMOTICS CONNECT 400
Operating Instructions, 04/2023, A5E50161952B AL
To identify an asset, press the motor icon (LED of the connectivity module flashes)
BLE name of the currently selected connectivity module
Bluetooth interface signal strength display
Wi-Fi configuration status of the connectivity module:
• "Black" status: Wi-Fi configured and operating correctly
• "Red" status: Wi-Fi not configured or has a fault
Connection status of the connectivity module to the MindSphere application SIDRIVE IQ Fleet
(onboarding status)
• "Black" status: Connected
• "Orange" status: No Onboarding yet
• "Red" status: Error during upload
Status of the connectivity module battery:
• "Black" status: sufficient charge
• "Orange" status: 40% or less
• "Red" status: 20% or less
*) Note: Replace the battery in good time. If disturbances occur in data transmission, replace the
batteries (Page 196).
"Connect" button to establish a connection to the connectivity module
If necessary, confirm a pairing request to establish the Bluetooth connection.
*)
Commissioning
6.2 Commissioning with Android
39