Powering Up; Initializing The System - Elmo Cello Installation Manual

Cello Installation Guide
MAN-CELIG (Ver. 1.5)
3.5

Powering Up

After the Cello has been mounted, check that the cables are intact. The Cello servo drive is
then ready to be powered up.
Caution:
Before applying power, ensure that the DC supply is within the range
specified for your specific type of Cello and that the proper
plus-minus connections are in order.
3.6

Initializing the System

After the Cello has been connected and mounted, the system must be set up and
initialized. This is accomplished using the Composer, Elmo's Windows-based software
application. Install the application and then perform setup and initialization according to
the directions in the Composer Software Manual.
Installation
3-39