Furuno FELCOM501 Operator's Manual page 197

Code Priority
0x3840C Error
0x3840F Error
0x38410 Error
0xB5400 Warning
0xB5402 Error
0x20000019 Warning
0x20000105 Warning
0x20000106 Warning
0x20000107 Warning
0x20001109 Warning
0x2000110A Info
Notification Message
BDU Web UI
Diagnostic test for Diagnostic test for
Communication Comm. Unit detect-
Unit detected an er- ed an error.
ror (Temperature
sensor).
Diagnostic test for Diagnostic test for
Communication Comm. Unit detect-
Unit detected an er- ed an error.
ror (GPIO).
Diagnostic test for Diagnostic test for
Communication Comm. Unit detect-
Unit detected an er- ed an error.
ror (Ethernet
switch).
Diagnostic test for Diagnostic test for
Communication Comm. Unit detect-
Unit detected an er- ed an error.
ror (LED).
Diagnostic test for Diagnostic test for
Communication Comm. Unit detect-
Unit detected an er- ed an error.
ror (PoE).
- No phone number
available.
Login failed too Login failed and
many times. Sys- locked.
tem has been
locked.
System is locked It has been locked
out. out.
- The telephone num-
ber cannot be used.
- No Communication
Unit found.
Unable to lease IP
address.
APPENDIX 3 NOTIFICATION MESSAGES
Explanation/Remedy
Handset
Diagnostic test for Communi-
cation Unit detects error
(Temperature sensor). Re-
start the Communication
Unit. If the problem persists,
contact your dealer.
Diagnostic test for Communi-
cation Unit detects error
(GPIO). Restart the Commu-
nication Unit. If the problem
persists, contact your dealer.
Diagnostic test for Communi-
cation Unit detects error
(Ethernet switch). Restart the
Communication Unit. If the
problem persists, contact
your dealer.
Diagnostic test for Communi-
cation Unit detects error
(LED). Restart the Communi-
cation Unit. If the problem
persists, contact your dealer.
Diagnostic test for Communi-
cation Unit detects error
(PoE). Restart the Communi-
cation Unit. If the problem
persists, contact your dealer.
No phone number available.
You need to release one of
the used numbers.
Login failed too many times.
System has been locked.
The phone number cannot
be used because the tele-
phone number might be used
for an another phone. Config-
ure the number again or se-
lect another number.
The Communication Unit is
not found. Check the network
configuration and connec-
tion.
- Maximum number of IP ad-
dresses have been leased.
Check the network configura-
tion where FELCOM system
is connected to. Also check
the DHCP configuration on
Web interface of the Commu-
nication Unit.
AP-21