Furuno FELCOM501 Operator's Manual page 151

5. Click [Add filter] button.
The following pop-up window appears.
6. Referring to the following table, set up the IP filter according to your application
and system.
Item
Action Select the IP filter action from "Pass", "Drop", or "Reject".
Select "Pass" to set "TCP/UDP(NAPT)" at [Protocol].
Filter Direction Select the IP filter direction from "WAN→LAN" or "LAN→WAN".
Select [WAN→LAN] to set [TCP/UDP(NAPT)] at [Protocol].
Destination Input, or change the destination address (IPv4 address).
Address
Source Ad- Input, or change the source address (IPv4 address).
dress
Protocol Select the IP filter protocol from "All", "ICMP", "Any", "TCP/UDP", or
"TCP/UDP(NAPT)".
• If [Protocol] is [Any] only, input the protocol number (1-255).
• If [Protocol] is [TCP/UDP] only, select "TCP", "UDP", or "TCP/UDP"
from the pull-down menu. then input the port number (range: 1-
65535).
• If [Protocol] is [TCP/UDP(NAPT)] only, select "TCP" or "UDP", then
input the port numbers for "Dest." and "From" (range: 1-65535).
Add button Register the setting information, then close the pop-up window.
Cancel button Cancel the setting information, then close the pop-up window.
7. Click the [Add] button.
The message "Applied." appears and the settings appear in the [IP Filter List].
8. Click the [Close] button to close the message.
6. SETTINGS ON WEB INTERFACE
Description
Filter settings appear in the IP Filter List.
6-41