Furuno FELCOM501 Operator's Manual page 150

6. SETTINGS ON WEB INTERFACE
Item
Add filter button
Delete button
Pri.
Action
Dir
Src. Addr.
Dest. Addr.
Protocol
Area
Import button
Export button
Change priority
Up button
Down button
Apply button
6-40
Create a new IP filter Up to 100 filters can be created. The cre-
ation pop-up window appears.
Delete items with check-marks [ ].
Put a [ ] in the box on the left side of the item to delete.
To select all IP filters, put a [ ] in the box beside the [Pri.] title.
Shows the priority.
The smaller the number the higher the priority.
Shows the IP filter action.
Shows direction in which the IP filter is applied.
Shows the source address.
If not set, "Anywhere" appears.
Shows the destination address.
If not set, "Anywhere" appears.
Shows the IP filter protocol.
• If [Protocol] is [Any], Shows the protocol number.
• If [Protocol] is [TCP/UDP]: Shows the port range.
• If [Protocol] is [TCP], [UDP]: Shows the port range or port
numbers for [Dest. Addr.] and [Src. Addr.].
Import the IP filter settings.
1) Click the [Import] button.
The message "Overwrite the IP filter list in this group. Are
you sure?" appears.
2) Click the [OK] button.
The [Open] dialog box appears.
3) Select the zip file of the IP filter settings to import, then click
the [Open] button.
The message "Input a password for the import file if neces-
sary" appears.
4) If a password was set when the filter settings were export-
ed, input the password.
5) Click the [OK] button.
6) Input the administrator password.
7) Click the [OK] button.
8) Click the [Close] button.
Export the IP filter settings.
1) Click the [Export] button.
The message "Input a password for the export file if neces-
sary." appears.
2) Input a password as necessary. This password will be re-
quested when the settings are imported.
3) Click the [OK] button.
The [Save] dialog box appears.
4) Click the [Save] button.
The DNS filter data is saved in zip format.
Note: Do not unzip the archives. Unzipped files cannot be
imported.
Raise the priority for the [ ] of the item.
The button appears in gray when there is no check, or multiple
checks.
Lower the priority for the [ ] of the item.
The button appears in gray when there is no check, or multiple
checks.
Apply the priority change.
Description