Furuno FELCOM501 Operator's Manual page 193

Code Priority
0x11005 Info
0x11006 Error
0x11007 Error
0x11008 Error
0x1100C Warning
0x1100E Warning
0x22600 Error
0x25800 Error
0x2580A Error
0x2580C Error
0x2580D Error
Notification Message
BDU Web UI
PoE device which
was previously con-
nected has been
disconnected.
PoE will be disabled PoE will be disabled
due to over/under due to over/under
voltage. voltage.
All PoE ports are All PoE ports are
shut down due to shut down due to
high temperature. high temperature.
PoE overload is de- PoE overload de-
tected. tected.
Unable to feed PoE Unable to feed PoE
power due to power power due to power
limit. limit.
PoE disabled on PoE power limit.
LAN port(s) due to
power limit.
No Antenna. No Antenna.
Diagnostic test for Diagnostic test for
Antenna detected Antenna detected
an error (HPA). an error.
Diagnostic test for Diagnostic test for
Antenna detected Antenna detected
an error (HPA cali- an error.
bration).
Diagnostic test for Diagnostic test for
Antenna detected Antenna detected
an error (Antenna an error.
module).
Diagnostic test for Diagnostic test for
Antenna detected Antenna detected
an error (No GPS an error.
module).
APPENDIX 3 NOTIFICATION MESSAGES
Explanation/Remedy
Handset
- PoE device which was previ-
ously connected has been
disconnected.
PoE will be disabled due to
over/under voltage. Restart
the Communication Unit. If
the problem persists, contact
your dealer.
All PoE ports are shut down
due to high temperature. Re-
start the Communication
Unit. If the problem persists,
contact your dealer.
PoE overload is detected.
Disconnect the PoE equip-
ment from LAN ports and re-
start the Communication
Unit. If the problem persists,
contact your dealer.
Unable to feed PoE power
due to power limit. Discon-
nect the PoE equipment from
LAN ports and restart the
Communication Unit.
PoE disabled on LAN port(s)
due to power limit. Discon-
nect some PoE equipment
from LAN ports.
No Antenna. Make sure the
connection between Antenna
and Communication Unit.
Diagnostic test for Antenna
detects error (HPA). Restart
the Communication Unit. If
the problem persists, contact
your dealer.
Diagnostic test for Antenna
detects error (HPA calibra-
tion). Restart the Communi-
cation Unit. If the problem
persists, contact your dealer.
Diagnostic test for Antenna
detects error (Antenna mod-
ule). Restart the Communi-
cation Unit. If the problem
persists, contact your dealer.
Diagnostic test for Antenna
detects error (No GPS mod-
ule). Restart the Communi-
cation Unit. If the problem
persists, contact your dealer.
AP-17