Furuno FELCOM501 Operator's Manual page 188

APPENDIX 3 NOTIFICATION MESSAGES
Code Priority
0x9120 Warning
0x9121 Warning
0x9122 Warning
0x9123
0x9124
0x9125 Warning
0x9126 Warning
0x9127 Warning
0x9128 Warning
0x9129
0x912A Warning
0x921E Warning
0x9221 Warning
AP-12
Notification Message
BDU Web UI
Satellite tracking Satellite tracking
might not be suffi- might not be suffi-
cient due to exces- cient.
sive ship motion.
Antenna software Antenna software
has internal errors. has internal errors.
Satellite tracking Satellite tracking
precision is not suf- precision is not suffi-
ficient. cient.
The zero point sen- The zero point sen-
sor in the Antenna sor in the Antenna is
is not on the zero not on the zero
point as it should point.
be.
MDM voltage in the MDM voltage in the
Antenna is out of Antenna is out of
range. range.
Antenna software Antenna software
has internal errors. has internal errors.
GPS module error. GPS module error.
The motors in the The motors in the
Antenna have Antenna have
stopped due to ex- stopped due to ex-
treme temperature. treme temp.
HPA voltage in the HPA voltage in the
Antenna is out of Antenna is out of
range. range.
Gain settings error Gain settings error
in HPA. in HPA.
Explanation/Remedy
Handset
Satellite tracking precision is
not sufficient due to exces-
sive ship motion. The system
must operate within the spec-
ified ship motion. See the
specifications page.
Antenna software has inter-
nal errors. Restart the Com-
munication Unit. If the
problem persists, contact
your dealer.
Satellite tracking precision is
not sufficient. Restart the
Communication Unit. If the
problem persists, contact
your dealer.
The zero point sensor in the
Antenna is not on the zero
point as it should be. Restart
the Communication Unit. If
the problem persists, contact
your dealer.
MDM voltage in the Antenna
is out of range. If the problem
persists, contact your dealer.
Antenna software has inter-
nal errors. Restart the Com-
munication Unit. If the
problem persists, contact
your dealer.
GPS module error. If the
problem persists, contact
your dealer.
The motors in the Antenna
have stopped because the
temperature is excessively
high or low. When the tem-
perature is within operating
limits, the motors automati-
cally restart. For information
on ambient temperature lim-
its, see the specifications
page.
HPA voltage in the Antenna
is out of range. Check input
voltage to the Communica-
tion Unit is within 10 – 32 V
DC. Make sure the antenna
cables are screwed together
firmly.
Gain settings error in HPA.
Restart the Communication
Unit. If the problem persists,
contact your dealer.