Training Courses; Delivery Conditions; Storage; Warranty And Liability - Bender ISOMETER isoPV1685RTU Manual

Important information

1.3 Training courses

Bender is happy to provide training regarding the use of test equipment.
The dates of training courses and workshops can be found on the Internet at

1.4 Delivery conditions

Bender sale and delivery conditions apply.
For software products, the "Softwareklausel zur Überlassung von Standard-Software als Teil
von Lieferungen, Ergänzung und Änderung der Allgemeinen Lieferbedingungen für Er-
zeugnisse und Leistungen der Elektroindustrie" (software clause in respect of the licensing
of standard software as part of deliveries, modifications and changes to general delivery
conditions for products and services in the electrical industry) set out by the ZVEI (Zentral-
verband Elektrotechnik- und Elektronikindustrie e.V.) (German Electrical and Electronic Ma-
nufacturers' Association) also applies. Amending the "General Conditions for the supply of
Products and Services of the Electrical and Electronics Industry" (GL)*
Sale and delivery conditions can be obtained from Bender in printed or electronic format.

1.5 Storage

The devices must only be stored in areas where they are protected from dust, damp, and
spray and dripping water, and in which the specified storage temperatures can be ensured.

1.6 Warranty and liability

Warranty and liability claims in the event of injury to persons or damage to property are
excluded if they can be attributed to one or more of the following causes:
• Improper use of the device.
• Incorrect mounting, commissioning, operation and maintenance of the device.
• Failure to observe the instructions in this operating manual regarding transport,
commissioning, operation and maintenance of the device.
• Unauthorised changes to the device made by parties other than the manufacturer.
• Non-observance of technical data.
• Repairs carried out incorrectly and the use of replacement parts or accessories not
approved by the manufacturer.
• Catastrophes caused by external influences and force majeure.
• Mounting and installation with device combinations not recommended by the
manufacturer.
This operating manual, especially the safety instructions, must be observed by all person-
nel working on the device. Furthermore, the rules and regulations that apply for accident
prevention at the place of use must be observed.
isoPV1685xxx_D00007_08_M_XXEN/03.2023
www.bender.de -> Know-how -> Seminars.
9