Table of Contents
Advertisement
8. Disconnect the Display data ribbon cable connector at the J10 location
on the Main PWA.
To remove the Left Cover Assembly:
1. Disconnect and remove all ink reservoirs.
Figure 5-2. Left Cover Removal/Installation.
2. Remove the two screws securing the Left Cover to the Left Frame. See
the upper portion of Figure 5-2.
3. Reach under the Support Bracket and depress and hold the retracting
stop assembly that secures the Left Cover to the Support Bracket.
4. Insert the tip of a flathead screwdriver into the gap between theLeft
Cover and the Left Frame as shown in the lower portion of Figure 5-2
and twist. Insert and twist into as many gaps as necessary to loosen
the cover from the frame.
5. Carefully lift the Left Cover up and off the printer.
NovaJet 800 Series Service Manual
Assembly\Disassembly
5-4
Advertisement
Table of Contents
