Table of Contents
Advertisement
10. Reinsert the right Foam Block. Make sure that the Stepper Motor and
Fan(s) cables are exiting out of the back corner of the Foam Block.
See Figure 5-31. The Foam Block is positioned between the Stepper
Motor and the Servo Motor. Make sure it is not tilted at an angle.
SERVICE
STATION
P/O LEG HARNESS
Figure 5-31. Inside Platen, Right Side.
11. Reinsert the Service Station.
12. Reinstall the Right Sideplate. Ensure that all cables from inside the
Platen are exiting out of the large hole in the Sideplate.
13. Reinstall the left Foam Block.
14. Reinstall the Left Frame Assembly.
15. Install the Ink Delivery System following procedures outlined earlier in
this chapter.
16. Install the Top, Left and Right Covers following procedures outlined
earlier in this chapter.
NovaJet 800 Series Service Manual
STEPPER
MOTOR
FOAM
BLOCK
Assembly\Disassembly
5-53
Advertisement
Table of Contents
