Table of Contents
Advertisement
Figure 5-29. Pinch Roller.
7. Spin the back of the pinch roller to either side and remove the back
spring.
8. Carefully tilt the back of the pinch roller upwards. This brings the front
of the pinch roller down, away from the Slide Shaft. Carefully remove
the spring that is going into the Slide Shaft from the top of the pinch
roller.
9. Remove the pinch roller.
10. From the bottom of the Y-Arm Assembly, remove the four screws that
secure the Slide Shaft and its two supports from the Y-Arm Assembly.
11. Remove the two screws that secure the AutoLoad Sensor to the Y-
Arm. Remove the AutoLoad Sensor wires from the four wire clamps on
the back part of the Y-Arm Bracket.
NovaJet 800 Series Service Manual
Assembly\Disassembly
5-46
Advertisement
Table of Contents
