Fire-Lite Alarms MS-9200E Programming, Installation, Maintenance And Operating Instruction Manual page 58

Program Change - Level One
arrow key is pressed with the blinking cursor on the last letter of the ADJ label, the cursor will move to the first letter
of the NOUN field.
Altering the NOUN field is done in a similar way. Use the up or down arrow keys to step through the NOUN library
which is listed below:
_________ (default of blanks)
BASEMENT_
BOILER_RM
CLASSROOM
CLOSET___
CORRIDOR_
ELECT._RM
ELEVATOR_
ENTRANCE_
FLOOR____
GARAGE___
HALLWAY__
In addition, the user may use the Recall/Increment function at any time when the cursor is on the first letter of the
ADJ or NOUN field as follows:
• If the zero is pressed, a '0' is placed in the first letter position
• If the zero key is then pressed a second time with no intervening key actions, the entire ADJ field is replaced
with the field entered for the previous device programmed, and the cursor moves to the last character of the
field (Recall function). The Recalled ADJ or NOUN field may now be changed letter-by-letter
• If the Zero key is pressed again with no other intervening key actions and the last character in the field is a
number '0-9', the number is incremented by one. If the last character is a letter, it changes to a '0'. If the last
character goes from 9 to 0 and the characters to the left of the last character are also numbers, they are also
incremented (overflow)
• The above increment function may be repeated with each press of the Zero key
As an example, the user could quickly enter 'FLR_3_ROOM_305' as follows:
The cursor is on the first letter of the ADJ field. Press the Zero key twice to display 'FLR_3'
1.
With the cursor on the first letter of the NOUN field, press the zero key twice to recall the display
2.
'ROOM_304'. The cursor automatically jumps from the first to the last letter of the NOUN field
With the cursor on the last letter of the NOUN field, press the Zero key again to increment the room number to
3.
'305'
Press the right arrow key to advance to the Zone field
4.
Select a zone number from 00 to 56. Z00 (default zone) is the general alarm zone. Z01 through Z56 may be
5.
selected to link software zones.
To load the addressable device's program into memory at any time, press the ENTER key. After pressing ENTER,
autoprogram displays the next new detector. If a detector had been previously entered into memory, but is missing
(no answer), the display shows the following:
58
HVAC_ROOM
KITCHEN__
LOBBY____
OFFICE___
PATIENT__
RESTROOM_
ROOM_____
STAIRWAY_
STOREROOM
WING_____
ZONE_____
Document #50428 Rev.C1 2/15/99 P/N 50428:C1