Table of Contents
Advertisement
Program Change - Level 2
the program change screen. If BACKSPACE is entered, the password remains unchanged and the program returns to
the program change screen.
3.3.6 Load
While displaying the Program Menu, program selection '5' sets up the MS-9200 for transfer of its application data-
base from/to a DOS-based or Window-based computer. This may be used to save the program that exists in an
MS-9200 for security and future service reasons; or may be used to transfer a program created off-line to the
MS-9200. Refer to the PK-9200(W) Manual for additional information. When the Load option is selected, the fol-
lowing screen will be displayed:
The left arrow key may be used to return to the program change screen. The PC connects to the EIA-232 printer
interface (instructions provided with the Upload/Download software kit). Continue to press the left arrow key to
return to the main program screen.
!
WARNING: Changes to program entries occur as a result of the downloading process. A fter successful
downloading, make certain to perform the following steps:
Print out all programmed data or manually view programmed entries and compare to intended program data.
1.
Test all affected panel operations.
2.
Immediately correct any problems found.
3.
3.4
Program Change - Level 2
While the MS-9200 system is normal with no active alarms, troubles or supervisories, the screen shown below will be
displayed:
To access the programming mode, the ENTER key must be pressed, causing the following screen to be displayed:
Document #50428
Rev. C1
2/15/99
P/N 50428:C1
63
Advertisement
Table of Contents
