Wiring Detectors - Fire-Lite Alarms MS-9200E Programming, Installation, Maintenance And Operating Instruction Manual

Wiring Detectors

2.14 Wiring Detectors
To install addressable detectors:
Connect the MS-9200 Communications SLC loop to Terminal (-) and (+) on the removable terminal block.
1.
If an RA400Z Remote LED Annunciator is being employed, connect the RA400Z positive terminal to the
2.
RA(+) terminal on the removable terminal block and the negative terminal to the RA(-) terminal on the remov-
able block.
Before installing the appropriate addressable detector head, set the detector's address on the head with a small
3.
flathead screwdriver. Mark this address on the head.
Place the removable terminal block into the connector in the detector head. Be certain to properly align and
4.
snap-in securely.
Wiring Detector with Removable Plug-in Connector
FIGURE 2-27:
Channel (+)
Communications
Channel (-)
SLC Loop
COMM
SD300 with removable
plug-in connector
Document #50428 Rev. C1
Channel (+)
Channel (-)
RA 400Z Remote LED
A nnunciator
2/15/99 P/N 50428:C1
to next device
on Loop
45