Table of Contents
Advertisement
5
Setting Hardware
Modbus TCP/IP support Network Adapter.
Modbus Serial support Network Adapter.
5-28
In order to complete Online function of IOGuidePro, please complete Hardware Setting for
communication.
1. Connect IO module to Network Adapter.
Tips: Wire diagram for each IO module of RSTi Technical Data.
2. Connect Cable (RJ-45) to Ethernet Port of PC.
3. Charge up power in Network Adapter.
1. Connect Serial Cable to Serial Port in PC.
2. Set Node Address. Be sure not to be duplicated in case of RS-485.
Refer to:
RSTi Technical
3. If necessary, set Serial Communication option through DIP Switch. RS-485
requires all the same.
(Factory Default as Baud Rate: 9600, Data Bit: 8, Parity: None, Stop Bit: 1)
Refer to:
RSTi Technical
Note:
IOGuidePro supports RTU communication only, do not change Communication
DIP Switch.
4. In order to apply for the changed setting value, please newly charge up power in
NA.
Refer to
System Requirement
RSTi Technical
RSTi Network Adapter Manual User Manual -January 2012
Data.
Data.
Data.
GFK-2746
Advertisement
Table of Contents
