Table of Contents
Advertisement
a. Connect the end marked "Riser" of the GPU power cord to the riser module and then
connect the other end of the power cord to the GPU module.
b. Insert the GPU into PCIe slot along the guide rails and fasten the screws to secure the
GPU to the riser module.
c. Use the cable ties provided with the riser module to secure the GPU power cord to the
cable tie holders on the side panel.
Figure7-12 Installing the GPU in the riser module
6.
Remove the access panel. For more information, see
7.
Remove the riser module blank. For more information, see
8.
Install the riser module installed with the GPU in the device. With a GPU or storage controller
installed, the riser module installation procedure is the same. For more information, see
"Installing a storage
9.
Use screws to secure the riser module to the chassis. For more information, see
storage
10. Install the access panel. For more information, see
Installing a DIMM
IMPORTANT:
For system identification, use the DIMMs recommended by H3C.
To install a DIMM:
controller."
controller."
"Installing a storage
"Installing a storage
"Installing a storage
17
controller."
controller."
"Installing a
controller."
Advertisement
Table of Contents
