Start Up Of The Hhc - Fuji Electric FCX-AII-V5 Series Instructions Manual And Service Instructions

4.3.2 Start up of the HHC

• Put on/off switch of the HHC on "ON" position.
Put on the enclosed "key" in the corresponding location of the HHC. Without the key and
with the key in vertical position, you can just read the transmitter parameters.
To write new parameters in the transmitter, the key needs to be in horizontal position.
Otherwise, you will have an inscription on the HHC screen "INHIBIT KEY OK ?" to let
you know that the key needs to be turned to enable the programming of new parameters
in the transmitter.
NOTA : "INHIBIT KEY" means that the key permits or inhibits (prohibited) writing para-
meters in the transmitter
• The transmitter version and the revision of the HHC software are indicated on the screen during
the start up.
After around 4 seconds the inscription "PUSH MENU KEY" appears (please push menu key)
HHC with the optional printer will have the inscription "PAPER FEED". Please push on <INC>
key. By pushing on <INC> key the paper feed is activated.
"PUSH MENU KEY" will be indicated on the screen by if you push on the clear <CL> key.
On the screen appears the inscription "RECEIVING START". The HHC reads out the data from
In case of a connection problem, "NO CONNECTION" will appear on the screen. The "PUSH
MENU KEY" appears again if you push the clear <CL> key.
The reasons of a communication problem can be :
- The 4-20 mA output is not powered.
- The 4-20 mA is disconnected.
- The loop resistance value doesn't correspond to the required one depending on the power
supply.
- The HHC is not connected to the correct terminals
steps are indicated on the bottom line of the screen inside following signs ( <
N+1), or the DEC (decrease
The <CHNG
the letter. To add a space between caracters, you have to push the keys <ALHA>, and
< >. To delete caracters, please use the clear key <CL>.
a second time on the enter < ENT
At this moment the new programmed information are written in the transmitter memory,
"WRITE" indication will appear on the screen of the HHC
48
INC (increase
The most important menus can
ALHA> key, each time before programming
CHNG OK ?
> ).
ENT> to send
-
INF-TN5FCXA2V5e-E