Table of Contents
Advertisement
Unpacking and Installation
Figure 3: Typical Polypropylene Tubing Adapter Installation
8
Unpacking
1.
Remove the unit from its shipping container.
Ensure that the ultrafilter, UV lamp, feed and reject
tubing, final filter, sanitization cartridge and power
cord are removed form the packaging materials
before discarding.
Tubing Adapter Installation
The following instructions will apply when you need to attach
a piece of tubing to your EASYpure UV/UF during installation,
unless otherwise noted in the installation instructions. To
make tubing connections:
1.
Completely disassemble the fitting. Refer to Figure
3 to familiarize yourself with the names of the com-
ponent parts.
2.
Make sure the tubing is cut off reasonably square
and that no plastic burrs or ridges are present.
3.
Place the grab ring and backup ring in the hex nut
in the order and orientation shown in Figure 3.
Thread the nut onto the adapter. DO NOT use the
o-ring at this time.
4.
Push the tubing through the nut until it bottoms out
in the adapter.
Advertisement
Table of Contents
