Table of Contents
Advertisement
Installation Manual
H3C LS8M1WCMA0-OVS Access Controller Module
Note:
The application files for system boot can be type M, B and S, but not type N/A (that
is, types other than M, B, and S).
You can modify the names of application files of type M, B and N/A except type S in
the BootWare menu or using commands after the application program boots.
The secure application file is the last resort for system boot. You cannot change the
type of the secure application file, or change other types of files to the secure
application file. You can only download it using the BootWare menu. If you change
the name of the secure application file with the rename command after the system
boots, the file is removed from the Flash. To use the secure application file, you
need to download it again.
There is only one file of the same type (M, B, or S) in the Flash. For instance, if there
is a file of type M+B in the Flash, there will not be other files of type M or B. If the type
of another file is changed to B, the original type M+B file changes to a file of type M.
III. Configuration file
The file stores configuration information of the LS8M1WCMA0-OVS card.
5.1.2 Software Maintenance Methods of the LS8M1WCMA0-OVS
Upgrade BootWare and application programs using XMODEM protocol through a
serial interface.
Upgrading application programs from TFTP server through Ethernet interface in
BootWare.
Upload/download application programs and configuration files to/from the
TFTP/FTP server through command lines.
Note:
The BootWare program is upgraded together with the host software program
version. That is, the system automatically upgrades the BootWare program when
you upgrade the host software program.
Check the current version of BootWare and application programs before upgrading.
For the association between the host software program version and the BootWare
program version, refer to the version configuration information in Release Notes.
Chapter 5 Software Maintenance
5-2
Advertisement
Table of Contents
