Installation Manual
H3C LS8M1WCMA0-OVS Access Controller Module
3.2 Installation/Removal of an LS8M1WCMA0-OVS
3.2.1 Removing an LS8M1WCMA0-OVS
Figure 3-2 Remove an LS8M1WCMA0-OVS card
Step 1: Turn off the power switch(es) of the switch;
Step 2: Loosen the captive screws at both sides of the card;
Step 3: Pull outwards the ejector levers of the card, and pull out the card along the
guide rails until it is completely separated from the slot of the switch.
3.2.2 Installing an LS8M1WCMA0-OVS
Step 1: Turn off the power switch(es) of the switch;
Step 2: Align the remote edge of the card with the slot guide rails, push the card into the
slot, push the ejector levers inward until it presses against the main control card panel
(the angles thus formed between the panel and the levers are the minimum angles).
step 3: Fix the LS8M1WCMA0-OVS card in the chassis by fastening the captive
screws.
3-3
Chapter 3 Installation