Installation Manual
H3C LS8M1WCMA0-OVS Access Controller Module
RJ-45
7
8
3.1.2 Connecting the Console Cable
Follow these steps to connect a terminal device, a PC for example, to your
LS8M1WCMA0-OVS card:
Step 1: Plug the DB-9 female connector of the console cable to the serial interface of
the PC or terminal where the LS8M1WCMA0-OVS card is to be configured.
Step 2: Connect the RJ-45 connector of the console cable to the console interface of
the LS8M1WCMA0-OVS card.
Caution:
Pay attention to the interface mark and plug the connector to the right interface.
Note:
For a powered-on LS8M1WCMA0-OVS card:
When connecting a PC to the LS8M1WCMA0-OVS card, you are recommended to
first connect the DB-9 connector of the console cable to the PC, and then the RJ-45
connector to the console interface of the LS8M1WCMA0-OVS card.
When disconnecting a PC from the LS8M1WCMA0-OVS card, you are
recommended to first disconnect the RJ-45 connector, and then the DB-9
connector.
Signal
Direction
DSR
←
CTS
←
3-2
Chapter 3 Installation
DB9 (MODEM)
DB9 (CONSOLE)
6
4
8
7