Table of Contents
Advertisement
Installation Manual
H3C LS8M1WCMA0-OVS Access Controller Module
Figure 5-10 Network diagram for maintenance of the LS8M1WCMA0-OVS serving as
a client
The LS8M1WCMA0-OVS card serves as an FTP client, while the PC running FTP
server serves as the FTP server. Set the FTP server path and add a username and
password for the LS8M1WCMA0-OVS card.
Configure the IP addresses of the two sides on the same network. In this section, the IP
address of the FTP server (PC) is set to 192.168.0.1, while that of the
LS8M1WCMA0-OVS is set to 192.168.0.2. You can use the ping command on the
server or the LS8M1WCMA0-OVS card to check whether the connection is successful.
Step 2: Maintain the LS8M1WCMA0-OVS card through the terminal connected to the
console interface of the LS8M1WCMA0-OVS card.
The following gives an example:
<H3C>ftp 192.168.0.1
Trying 192.168.0.1 ...
Press CTRL+K to abort
Connected to 192.168.0.1.
220 3Com 3CDaemon FTP Server Version 2.0
User(192.168.0.1:(none)):guest
configured on the server
331 User name ok, need password
Password:
password
230 User logged in
[ftp]
Use the following commands to maintain the LS8M1WCMA0-OVS card after logging in.
Here again, the get and put commands are used to restore and back up files.
[ftp]get main.bin main.bin
server to the LS8M1WCMA0-OVS
cf:/main.bin has been existing. Overwrite it?[Y/N]:y
200 PORT command successful.
150 File status OK ; about to open data connection
Chapter 5 Software Maintenance
card
5-21
Enter
the
username
Enter the corresponding
Connection succeeded.
Download the file from the
Overwrite the file
Advertisement
Table of Contents
