Mounting - Bender COMTRAXX CP9 Series Manual

Only quali ed personnel are permitted to carry out the work necessary to install, commission and run a
device or system.
CAUTION
Functional earth
The device must be earthed. Without connection of the functional earth, the device function is not
guaranteed.
Electrostatic sensitive components
Observe the precautions for handling electrostatic sensitive devices.
Damage to components
Do not remove the device from the enclosure while it is in operation. Disconnect the device from the
supply voltage and from the network (Ethernet) beforehand.
Damage to the device due to incorrect connector plug
Connector plugs of other devices may have di erent polarity. Make sure to use the supplied connector
plug.
Protective separation
The power supply must be properly separated from hazardous voltages and meet the limit values of
UL/CSA 61010-1, clause 6.3.
The CP9xx touch panel can be integrated into existing LAN structures or operated via a single PC.
If you are familiar with the con guration of computer networks, you can carry out the connection of the
CP9xx alarm indicator and operator panel yourself. Otherwise please contact your IT administrator!
4.1

Mounting

The COMTRAXX® CP9xx devices are installed
• either in the supplied and professionally pre-assembled ush-mounting enclosures
• or in an optionally available surface-mounting enclosure (CP907 only)
Special variants with modi ed enclosure depths or surface-mounted variants are available on request.
COMTRAXX® CP9xx – Control Panel
CP9xx_D00349_09_M_XXEN/03.2023 13