Mounting, Connection And Commissioning; Mounting The Cp9Xx Device - Bender COMTRAXX CP9 Series Manual

4. Mounting, connection and commissioning

Only qualified personnel are permitted to carry out the work necessary to install,
commission and run a device or system.
Functional earth
The device must be earthed. Without connection of the functional earth, the device
function is not guaranteed.
CAUTION
Electrostatic sensitive components
Observe the precautions for handling electrostatic sensitive devices.
Damage to components
Do not remove the device from the enclosure while it is in operation. Disconnect the
device from the supply voltage and from the network (Ethernet) beforehand.
Damage to the device due to incorrect connector plug
Connector plugs of other devices may have different polarity. Make sure to use the
supplied connector plug.
Protective separation
The power supply must be properly separated from hazardous voltages and meet
the limit values of UL/CSA 61010-1, clause 6.3.
The CP9xx touch panel can be integrated into existing LAN structures or operated on a single PC.
If you are familiar with the configuration of computer networks, you can carry
out the connection of the CP9xx alarm indicator and operator panel yourself.
Otherwise please contact your IT administrator!
4.1

Mounting the CP9xx device

The COMTRAXX® CP9xx devices are installed
either in the supplied and professionally pre-assembled flush-mounting enclosures

or in an optionally available surface-mounting enclosure (CP907 only)

Special variants with modified enclosure depths or surface-mounted variants are available on request.
14
Mounting, connection and commissioning
CP9xx_D00349_08_M_XXEN/02.2022