Bender COMTRAXX CP9 Series Manual page 34

Technical data
Interfaces
Ethernet
Connection
Cable
Cable length
Data rate
HTTP mode
DHCP
t (DHCP)
off
IP address
Net mask
Protocols
BMS bus
Interface/protocol
Operating mode
Baud rate
Cable length
Cable
recommended
alternative
Connection
Terminating resistor
Device address
BCOM
Interface/protocol
Cable length
BCOM system name
BCOM subsystem address
BCOM device address
34 CP9xx_D00349_09_M_XXEN/03.2023
shielded, both ends of shield connected to PE
nnn.nnn.nnn.nnn (192.168.0.254)*,
always reachable via: 169.254.0.1
nnn.nnn.nnn.nnn (255.255.0.0)*
TCP/IP, Modbus TCP, Modbus RTU, PROFINET, DHCP,
shielded, one end of shield connected to PE
twisted pair, J-Y (St) Y min. 2x0.8
'ABMS', 'BBMS' (see plug-in terminal)
120 (0.25 W), can be switched on internally (see plug-
RJ45
< 100 m
10/100 Mbit/s, autodetect
HTTP/HTTPS (HTTP)*
on/off (off)*
5...60 s (30 s)*
SNMP, SMTP, NTP
RS-485/BMS internal
master/slave (master)*
9.6 kBit/s
< 1200 m
CAT6/CAT7 min. AWG23
in terminal)
1...150 (1)*
Ethernet/BCOM
< 100 m
(SYSTEM)*
1...255 (1)*
0...255 (1)*