General Safety Instructions - Bosch Climate Line 2000 Installation Instructions Manual

Explanation of symbols and safety instructions
Symbol Meaning
For more information, refer to the technical
documentation.
Maintenance by a qualified person should be done
while following the instructions of the service manual.
For operation follow the instructions of the user
manual.
Symbol for rated heating capacity
Symbol for rated cooling capacity
Symbol for refrigerant circuit with high pressure side
(top) and low pressure side (bottom)
EAC conformity mark for merchandise which is
available on the market of the Member States of the
Eurasian Economic Union
Symbol indicates that electrical and electronic
appliances must be disposed of separately.
Table 1
1.2

General safety instructions

H Notices for the target group
These installation instructions are intended for
qualified persons who are skilled in dealing with
refrigeration engineering and HVAC technology and
also electrical systems. All system-relevant
instructions must be observed. Failure to comply with
instructions may result in material damage and
personal injury, including danger to life.
▶ Before carrying out the installation, read the
installation instructions of all system components.
▶ Observe the safety instructions and warnings.
▶ Follow national and regional regulations, technical
regulations and guidelines.
▶ Record all work carried out.
22
H Intended use
The indoor unit is intended for installation inside the
building with connection to an outdoor unit and
further system components, e.g. controls.
The outdoor unit is intended for installation outside
the building with connection to an indoor unit or units
and further system components, e.g. controls.
Any other use is considered inappropriate. Any
damage that may result from misuse is excluded from
liability.
For installation at special locations (underground
garage, mechanical rooms, balcony or at any semi-
open areas):
▶ First refer to the requirements for the installation
site in the technical documentation.
H General dangers posed by the refrigerant
▶ This appliance is filled with refrigerant R410A. If
the refrigerant gas gets into contact with fire, it may
generate toxic gas.
▶ Thoroughly ventilate the room if refrigerant leaks
during the installation.
▶ Check the tightness of the system following the
installation.
▶ Do not to let any other substance than the specified
refrigerant (R410A) into the refrigerant cycle.
H Safety of electrical devices for domestic use
and similar purposes
The following requirements apply in accordance with
EN 60335-1 in order to prevent hazards from
occurring when using electrical appliances:
"This appliance can be used by children of 8 years and
older, as well as by people with reduced physical,
sensory or mental capabilities or lacking in experience
and knowledge, if they are supervised and have been
given instruction in the safe use of the appliance and
understand the resulting dangers. Children shall not
play with the appliance. Cleaning and user
maintenance must not be performed by children
without supervision."
"If the power cable is damaged, it must be replaced by
the manufacturer, its customer service department or
a similarly qualified person, so that risks are avoided."
Climate Line 2000 – 6721831695 (2021/02)