Discontinue
The product is supplied for use by the persons who have
CAUTION:
proper expertise in electrical or mechanical engineering.
CKD will not be liable for bodily injuries or accident
caused by the use by the people who has no or little
knowledge in electrical and mechanical fields, and by the
people who is not thoroughly trained for using ABSODEX.
Do not overhaul the actuator unit as original functions
and accuracy may not be restored. This is especially so
with the resolver leading to fatal damage.
Do not hit the output axis with a hammer or assemble the
actuator with excessive power to maintain the designed
accuracy and performance.
Actuators except for AX8000 and the drivers are not
water-proof type. For using them where water or oil may
be splashed, provide a protective means for the actuator
and the driver.
Use the furnished cable only for connecting the driver to
the actuator. Install the cable so that no excessive
stresses are applied or no physically damage is made to
the cable. Changing the length or the material of the
furnished cable should not be done as performance
function may be lost or malfunction may be caused.
Standard accessory cable is not designed for use under
repeated
bending.
For
applications
accompanying
repetitive bending actions, use optional moving cables.
The full performance is not achieved in the shipment
state. Adjust the gain without fail.
With a non-compatible type (H type), the actuator and the
driver must be marked with the same serial number. With
different
combination
of
the
actuator
and
driver,
malfunction and failure may be caused.
To perform a dielectric voltage test to mechanical
equipment equipped with ABSODEX, disconnect the
main power cables (R, S and T or, for GH type and CE,
L1, L2 and L3) from the ABSODEX driver so that the
voltage is not added to the driver itself. Otherwise failure
may be caused.
When carrying the actuator, do not hold the connector or
connector mount.
The output axis may move from the holding position even
without an external force if the power or servo is turned
off or the torque limit setting is decreased from the
servo-on state (retention state).
[SMB-14E]
— iii —
Need help?
Do you have a question about the AX Series and is the answer not in the manual?