CKD AX Series Instruction Manual page 175

12
COMMUNICATION
FUNCTIONS
(3) NC Program Input (L11) and its Return Value
Inputting NC program to the ABSODEX driver will send out NC program following L11.
The return value is "0" for normal, and if there is a problem with the sent NC program, the
block number in question and the error content number are returned.
Return value
[Block Number] _ [Error Number] CR LF
Block number is assigned serially with 1 for the head block.
Error Number:
Programs and parameters can be re-written 100, 000 times.
[SMB-14E]
Discontinue
0 Not defined
1 No program number or M30
2 The codes of the same group that cannot be written together exist in the
same block.
3 Out of data setting range or the program memory is full.
4 Speed designation has not be made.
5 Non-defined code
6 Program number already registered has been specified.
7 O code is duplicated in the same program number.
8 Incorrect use of P code
9 No data to follow the code or data only without code
— 12-2 —