Procedure: Configure The Com Port - Cisco ONS 15200 Handbook

Chapter 2 Network Control Board Module

Procedure: Configure the COM Port

Select Start > Programs and select Accessories > Communication > Hyper Terminal.
Step 1
Press Cancel.
Step 2
In the File pull-down menu, select Properties (the window is called "New Connection Properties").
Step 3
In Connect using, select the COM
Step 4
In the "COMx properties" window, select:
Step 5
Baud rate
Data bits
Parity
Stop bits
Flow control
Press OK.
Step 6
In New Connection Properties, select the Settings menu.
Step 7
Select
Step 8
Go to ASCII settings. Mark Send line ends with line feeds (all other fields are not marked). The
Step 9
Hyperterminal screen appears.
Press Enter. The system responds with a login prompt. Press Enter again. Because no password is
Step 10
needed press Enter a third time. You should now see the NCB:> prompt.
Note
Create a user with administrator privileges:
Step 11
a.
b.
c.
d.
e.
Set the IP address of the NCB module.
Step 12
a.
b.
c.
Note
Disconnect the CIM RS-232 adapter cable.
Step 13
The Subnetwork Manager on the NCB module now has an IP address and can be accessed directly at the
Ethernet port on the NCB module.
78-13767-01
19200 Baud
8
None
1
None
as the emulation.
VT100
If you cannot see a response from the ONS 15252 MCU, try using a different COM port
At the NCB:> prompt, type
a "Created <user1>" message. The user1:# prompt appears on the screen.
At the user1:# prompt, type
new user.
At the user1:# prompt, type
At the user1:# prompt, type
At the NCB:> prompt type
At the NCB:> prompt, type
At the NCB:= prompt, type
IP address, subnet the chosen subnet mask, and gateway the gateway for the new NCB. Press
Enter.
At the NCB:= prompt, type
The NCB reboot takes approximately 1 minute.
Port. Press Configure.
x
create user <user1>
password <password1>
privileges administrator
and press Enter.
exit
commit user <user1>
and press Enter.
configure system
ipconf <ipaddr> <subnet> <gateway>
and press Enter.
reboot
Removing and Replacing an NCB Module
and press Enter. The system responds with
and press Enter to create a password for a
and press Enter.
where ipaddr is the chosen
Cisco ONS 15200 Module Handbook
2-9