Figure 14-5 90/10 Split Ratio (Protected) Connections - Cisco ONS 15200 Handbook

Removing and Replacing a CFM
Caution
Carefully insert the CFM into the ONS 15201 SCU. Guide the MU connectors to come out on the front
Step 3
of the SCU.
Align the four holes in the CFM case with the four module stand-offs located inside the ONS 15201
Step 4
SCU. When properly aligned the module stand-offs will fit into the holes in the CFM case.
Fasten the CFM to the module stand-offs with four retaining screws.
Step 5
Clean and inspect the optical connectors one at a time before they are connected.
Step 6
Note
Connect the CFM optical fiber jumper cables to the A-side and B-side adapters (SC to SC) in accordance
Step 7
with the labels located on the cables and
Note
Figure 14-5

Figure 14-5 90/10 split ratio (protected) connections

Side B
OUT
Figure 14-6
Cisco ONS 15200 Module Handbook
14-8
Be careful not to damage the optical fiber cables while inserting the module.
It is critical to always clean the connectors before mating them with other connectors.
For detailed instructions on connecting the CFM optical fiber, refer to the Cisco ONS 15200
Installation, Setup, and Test Manual.
displays the connection information for the 90/10 optical signal split ratio.
1
IN
2
SC
MU
Fusion splice
displays the connection information for the 10/90 optical signal split ratio.
Figure 14-5 through Figure
10
Chapter 14 Collector Filter Module
14-9.
4
OUT
Side A
3
IN
90
Rx A
CLIP
Rx B
Tx
78-13767-01