Figure 5-6 Connecting The Nam To The Clip Module - Cisco ONS 15200 Handbook

Chapter 5 Network Adaptation Module
Connect the three (or two unprotected) MU connectors from the NAM to the three (or two unprotected)
Step 4
MU adapters in the corresponding CLIP module. Begin with the inner connectors, labeled A and B, and
connect the outer transmitter connector last.
Remove the dust cap from the relevant MU connector.
Step 5
Clean and inspect the relevant MU connector.
Step 6
Remove the dust plugs from the relevant MU adapter.
Step 7
Figure 5-6
Optical Connectors (3)
One at a time, remove dust plugs from the HFM and remove fiber caps from NAM duplex MU
Step 8
connectors.
Clean and inspect the optical fiber connectors.
Step 9
Connect one (unprotected) or two (protected) duplex MU connectors from the NAM to the HFM
Step 10
(unprotected) or HFMs (protected). Use the labeling on the fiber to ensure that the A-side and the B-side
of the node are not interchanged.
78-13767-01
Connecting the NAM to the CLIP module
CLIP Module
NAM Module
Figure 5-7
Figure 5-6 shows a connected NAM and CLIP module.
shows a NAM connected to an HFM.
Cisco ONS 15200 Module Handbook
Removing and Replacing a NAM
5-9