Tektronix AWG5000B Series Service Manual page 73

Removal and Installation Procedures
DVD-ROM Drive
DVD-ROM Board
4–30
You need a screwdriver with a T-15 Torx tip and a #1 Phillips screwdriver (items
1, 2, and 5).
Removal. To remove the DVD-ROM drive, follow these steps: (See Figure 4-15
on page 4-31.)
1. Remove the handle unit, snaps, cosmetic covers, front-trim unit, EMI covers,
MIO board enforcement bracket, hard disk assembly, and drive-bay module.
2. Remove the two screws securing the DVD-ROM bracket to the drive-bay
chassis.
3. Slide the DVD-ROM drive with bracket out from the drive-bay chassis.
4. Remove the four screws securing the DVD-ROM drive to the bracket.
Installation. To install, reverse this procedure.
You need a #1 Phillips screwdriver (item 5).
Removal. To remove the DVD-ROM board, follow these steps: (See Figure 4-15
on page 4-31.)
1. Remove the handle unit, snaps, cosmetic cover, front-trim unit, EMI covers,
MIO board enforcement bracket, hard disk assembly, and drive-bay module.
2. Remove the two screws securing the DVD-ROM board to the DVD-ROM
drive.
3. Disconnect the cable from J1 on the DVD-ROM board.
4. Disconnect the interface cable on the DVD-ROM board.
5. Lift the board away from the DVD-ROM drive.
Installation. To install, reverse this procedure.
AWG5000B and AWG5000C Series Service Manual