Connecting The Drive And Power Cables - Epson ActionTower 7500 User Manual

Connecting the Drive and Power Cables

If your IDE device cable is already
interface, follow the steps in this section to connect the cable to
the drive.
Note
Make sure you connect a CD-ROM drive to the secondary
IDE interface; do not use same cable for a hard disk drive
and a CD-ROM drive.
Follow these steps to
1. Locate the connector at the end of the ribbon cable.
Locate
2.
Connector.
3. Position the connector on the cable so that the red wire aligns
with pin 1 on the drive.
connect the drive and power
pin 1 on the drive connector next to the power
Installing and Removing Slimline Drives
connected to the IDE
cables:
5-19