Using The System Setup Option; Checking System Memory - Epson ActionPC 5000 User Manual

Using the System Setup Option

When you select this option, you see the System Setup screen.
From this screen, you can set the system time and date, define
your video display type, check system memory, and define the
diskette drives.
Move the cursor to the value you want to change. Then
increase or decrease the value until you see the one you want.
Setting the time and date
The real-time clock in your computer continuously tracks the
date and time-even when the computer is turned off. Once
you set the System Time and System Date options, you
should not need to change them, unless you adjust the time for
daylight savings or a different time zone. (The computer
automatically changes the date for leap years.)
Setting the video display type
The Video System option allows you to define the type of
display you are using. If you have connected a VGA or SVGA
monitor to the computer's built-in VGA port, select EGA/VGA.
If you connected a monitor that doesn't support VGA to a
video adapter card installed in your system, select either the
CGA 80 x 25 or the Monochrome option. If you installed a
video adapter card, make sure you disable the on-board SVGA
controller by setting jumpers J20 and J21 to the Off position.
(See Chapter 4 for information on jumper settings.)

Checking System Memory

When you boot your system, the system BIOS updates the
memory size automatically. You see the memory configuration
displayed in the System Memory and Extended Memory
fields on this SETUP screen.
2-4 Running SETUP and Installing Drivers