Epson ActionPC 5000 User Manual page 90

3. Position the system board connector end of the cable so that
the red wire aligns with pin 1 of the connector on the
system board. There is a "1" printed on the system board to
identify pin 1.
connector
4. Make sure the holes in the connector fit over the pins; then
push in the cable connector.
could severely damage your system board when you push
Connecting the ribbon and power cables to the drive
Follow these steps to connect the hard disk drive ribbon cable
and a power supply cable to the drive:
1. Locate the hard disk drive connector on the end of the hard
disk drive ribbon cable.
Installing and Removing Drives
5-10