The Computer Does Not Respond - Epson ActionPC 5000 User Manual

Hide thumbs Also See for ActionPC 5000:
Table of Contents

Advertisement

You installed or removed system components, and now
your computer does not start.
Check to make sure you have reconnected all the internal and
external cables correctly.
You may have installed a SIMM incorrectly. If the system
doesn't detect memory, it won't start. Check that your SIMM(s)
are securely installed in their sockets.
If you replace the microprocessor, make sure the new processor
chip is installed correctly, and that the dot on the chip is
aligned correctly on the system board. If you did not align the
chip correctly, the system won't start. Also make sure jumpers
J8, J9, and J10, as well as jumpers J11 through J13, are set
correctly for your microprocessor. See Chapter 4.

The Computer Does Not Respond

The computer locks up.
Wait a few moments; if your computer does not respond after a
reasonable length of time, press Ctrl Alt Del. If that doesn't
work, press the RESET button.
You may have installs memory using SIMMs that work at the
wrong speed. Install the correct SIMMs (see Chapter 4).
Your system may have overheated. If you upgraded the
microprocessor yourself, make sure you have an adequate heat
sink installed on the chip.
You reset the computer, but it still does not respond.
Try turning the computer off, wait 20 seconds, and turn it on
again.
6-4
Troubleshooting

Advertisement

Table of Contents
loading

Table of Contents