Using Setup - Epson ActionPC 5000 User Manual

Chapter 2
Running SETUP and Installing Drivers
Your computer has a configuration program, SETUP, contained
within the BIOS chip on the system board. This program allows
you to change the settings for your hardware configuration.
The computer also comes with several drivers and utilities on
diskette, which may be already installed on your hard disk.
These drivers and utilities let you take advantage of some of
the advanced features of your system, like the local bus hard
disk drive interface and the local bus SVGA capabilities of the
built-in video interface.
This chapter describes using SETUP and installing the local bus
IDE driver. If you want information about installing video
drivers or utilities, see the README.TXT file included on
Drivers diskette 2.

Using SETUP

You may need to run the SETUP program the first time you use
your computer. If your system came unconfigured, you need to
define how it is set up. If your system was configured for you,
you may want to check the settings or adjust the date and time.
You also may need to run SETUP again later if you change
your configuration.
SETUP lets you verify or change the following:
of video display
Running SETUP and Installing Drivers 2-1