Resetting The Computer; Stopping A Command Or Program - Epson ActionPC 5000 User Manual

Stopping a Command or Program

You may sometimes need to stop a command or program while
it is running. If you have entered a DOS or application program
command that you want to stop, try one of the following:
If these methods do not work, you may need to reset the
computer as described below. Do not turn off the computer to
exit a program or stop a command unless you have to, because
the computer erases any data you did not save.

Resetting the Computer

Occasionally, you may want to clear the computer% memory
without turning it off. You can do this by resetting the
computer.
For example, if an error occurs and the computer does not
respond to your keyboard entries, you can reset it to reload
your operating system and try again. However, resetting erases
any data in memory that you have not saved; so reset only if
necessary.
Caution
Do not reset the computer to exit a program. Some programs
classify and store new data when you exit them. If you reset
the computer without properly exiting a program, you may
losedata.
Using Your Computer
3-5