Inserting SIMMs
Make sure the computer is turned off and the cover is off. Then
follow these steps to install SIMMs:
1.
Refer to the illustration on page
sockets on the right side of the system board, next to the
power supply connector.
2.
Remove any option cards that may be blocking your access
to the SIMM sockets. (See page 4-19 for instructions.)
3.
Turn the computer around so the back panel is facing you.
4.
Position the SIMM at an angle over the empty SIMM socket,
as shown below, aligning the notch in the middle of the
SIMM with the separator in the center of the socket.
4-5
to locate the SIMM
Installing and Removing Options
4-13